Search results for "Surface finishing"
showing 4 items of 4 documents
Effect of surface finishing on the oxidation behaviour of a ferritic stainless steel
2017
Abstract The corrosion behaviour and the oxidation mechanism of a ferritic stainless steel, K41X (AISI 441), were evaluated at 800 °C in water vapour hydrogen enriched atmosphere. Mirror polished samples were compared to as-rolled K41X material. Two different oxidation behaviours were observed depending on the surface finishing: a protective double (Cr,Mn) 3 O 4 /Cr 2 O 3 scale formed on the polished samples whereas external Fe 3 O 4 and (Cr,Fe) 2 O 3 oxides grew on the raw steel. Moreover, isotopic marker experiments combined with SIMS analyses revealed different growth mechanisms. The influence of surface finishing on the corrosion products and growth mechanisms was apprehended by means o…
Influence of initial treatments of aluminium on the morphological features of electrochemically formed alumina membranes
2003
Abstract The fabrication of alumina membranes by electrochemical oxidation of annealed aluminium was investigated. Porous layers were grown in 0.4 M H3PO4 at −1 and 5 °C at different anodising times. The morphology of the outer surface was found to be dependent on temperature and charge density, with both determining the extent of chemical dissolution of the anodic oxide. The inner-surface morphology was found to depend on the applied voltage only. The chemical dissolution rate of anodic oxide grown on annealed aluminium was found to be lower than that formed on unannealed aluminium under otherwise identical conditions. Such a difference in behaviour is explained in terms of a higher finish…
Numerical and Experimental Analysis of Convection Transfer During Melting by a Mono-Pulsed Laser
2010
This paper presents a comparison between simulation and experimental results of the melting process of metallic material by a pulsed laser source Nd-YAG. Variations of the thermophysical properties were considered. Furthermore, the model included the effects of the surface-tension gradient on the fluid surface and the buoyancy force. The keyhole effect induced strong surface deformations and often formed cavities, which arre undesirable in the surface treatment process. An experimental study of the surface profile of the melted zones was also conducted to seek a relationship between the so-called keyhole effect and the laser triangulation measurements. The predicted Laser Melted Zone (LMZ) …
The Relevance Of The Preform Design In Coining Processes Of Cupronickel Alloy
2007
Coining is a forging process in which a metallic disk, characterized by a low volume‐surface ratio, is deformed with the aim to impress 3D images on its three surfaces. Due to the large production volumes and, at the same time, to the high quality standards required to the final products in terms of final dimensions, tolerances and surface finishing, such closed‐die, cold forging process requires a careful evaluation and choice of the proper operative parameters. In particular, along with technological parameters as the die velocity, die stroke and lubrication, which, in turn, contribute to affect the pressure values on the die surfaces, and thus the press choice, geometrical parameters as …